Multimeter Selection And Inspection

Multimeter Selection And Inspection


This is the third lesson in the Multimeters Course. This lesson trains the learner in the inspection of a multimeter, the steps that should be taken before using a multimeter, and how to perform a continuity check.

Module Objectives

  • Identify the steps in inspecting a multimeter.
  • List the steps you should take before using a multimeter.
  • Define continuity and perform a continuity check.


This course consists of five modules designed to provide training for persons working with electrical or electronic test equipment. These lessons demonstrate and explain how to use both a digital and an analog multimeter. During these lessons, voltage, resistance, current, capacitance, and frequency are measured. The final lesson also describes some of the more common features of a digital multimeter.


There are no reviews yet.

Be the first to review “Multimeter Selection And Inspection”

Your email address will not be published. Required fields are marked *